As a new round of advertising products in the new era, luminous vehicle logo not only has a very exquisite appearance, but also can convey more intuitive publicity information and provide lighting in the dark. Therefore, in the past two years, such a large vehicle logo has won the love of countless businesses and enterprise users.
No matter how good the product is, after long-term use, there will be more or less failure problems. So what should the operator pay attention to when repairing the luminous logo? See below.
When carrying out the equipment and dismantling the luminous logo, the operating technicians should wear operation gloves that meet the regulations, so as to prevent the sweat, oil salt and other corrosive components on the hands from damaging the surface of the logo and affecting the beauty of the surface.
When removing the equipment or the outer frame of the luminous logo, remember to handle it with care and keep it stable. Don't bump or other serious friction in the process, and then place the outer frame on the ground. Remember to unplug the plug and disconnect the power supply of the luminous logo before the procedure of turning off the equipment and dismantling. In addition, live operation is prohibited for the inspection and repair of all electrical components.
After the repair is completed, the equipment shall be equipped with the vehicle logo. Be sure to check whether the upper power line is in the receiving and branch slot of the power supply. If not, remember to correct it. If the whole luminous logo is not on, the relevant repair personnel should check whether the leakage protection equipment is closed, whether the wire connector of the plug is loose, whether the connector of the relevant input and output equipment is in poor contact, etc.
If the light-emitting vehicle logo is on for a moment and not on for a moment, it may be due to the aging of wires, plugs and lamps. At this time, it only needs to be replaced in time to solve the problem. If there is a loud noise in the logo from time to time, the ballast may be aging at this time. We can replace a new ballast, but keep in mind that the model and manufacturer should be consistent as far as possible.